15k 4200w Ultrasonic Welding Machine For Auto Lamp

In daily life, we will see all kinds of lights on the road, and some cars can be welded with Ultrasonic Welder, because ultrasonic plastic welding can weld plastic lamp shells together into a complete lampshade.

Pure electric vehicle LED direction light is mainly composed of acrylic board PC board mask, ABS cover, integrated ic LED lamp beads, moisture-proof soft vulcanized rubber fixed anti-shake rod, ABS tail six parts.

Due to its tightness requirements, applications need to be combined with Ultrasonic Welding Machine during assembly. Get rid of the original splint mode, not only solve the problem of high efficiency, but also ensure the environmental protection and cleanliness of the production line. The following aspects should be paid attention to in the welding production process:

1. When making ultrasonic welding head, a gap of 1mm must be left according to the three-dimensional diagram. An excessively large transition fit can scratch the surface of the product and damage the appearance throughout the welding process.

2. In the production and manufacturing involves the use of two special tools for a product, because the two molds must be assembled to be fully assembled, and pay attention to the consistency of the contact surface when assembling the mold The product and adjust the Ultrasonic Plastic Welder.

Secondly, adjust rock bottom mold and welding horn of the Ultrasonic Plastic Welding Machine, activate the atmospheric pressure source, adjust the pressure to 2kg/cm, and place rock bottom mold steadily on rock bottom bed during a more convenient operation direction. Turn the machine lifting handwheel to 100 mm below the working surface of the welding head, activate the most power turn on the vibrating box, and set the selector on the ultrasonic plastic welding machine to the manual position.
Adjust the welding head of the ultrasonic plastic welding machine, loosen the four horizontal adjustment screws, align the welding head position with the workpiece, turn the machine lifting hand wheel, press the welding head to the workpiece, adjust the position of rock bottom mold, and make the welding head match the workpiece then , fix four horizontal screws on the average , fix rock bottom mold again, and switch the machine lifting hand wheel to lower the machine to the position of the welding machine, and await welding.
Finally steel oneself against welding, manually select the switch position of the ultrasonic plastic welding machine, press the up and down button on rock bottom bed, check the welding situation, set the descending speed and dealing pressure, adjust until there's no noise when lifting, and set the welding time. After debugging, you'll formally use the ultrasonic plastic welding machine for welding production work.