35khz ultrasonic handheld welding machine

parameter

The safe use of ultrasonic spot welding machines mainly has three aspects: test welding before formal welding, maintenance of the machine, and operation during welding.
1. 35K Spot Welding Machine test  before formal welding
The test welding operation can effectively detect problems with spot welders by following these steps:
(1) Adjust the current, the specific value depends on the situation;
(2) When welding, try to reach the appropriate position from the beginning of the short circuit;
(3) It is recommended to select low pressure and production time at the beginning of the test welding, which is safer;
(4) In the process of test welding, adjust the current size, welding time length and pressure size at any time according to the situation of the test welding plate until it is appropriate.

2. Hand-Held Ultrasonic Spot Welding Machine maintenance

Without the maintenance of the machine, no machine can be safely used, so how to maintain the spot welding machine?

(1) In order to ensure the drying of handheld spot welding machines, especially air compressors and filters, because water and small particles in the air are often compressed and filtered, it is necessary to regularly check and clean the water.

(2) When the air is input, some mist oil can be added, which can strengthen the lubrication of the equipment and reduce wear.

(3) Once the parameters are set, do not change them arbitrarily in use.

(4) Keep the machine clean.

3. During the welding process, the operation should comply with the safety operating procedures, especially care not to put the hand between the two electrodes.