Battery Case Hot Plate Welder

Plastic Hot Plate Welding Machine basic safety standards

This plastic pneumatic Hot Plate Welding Machine should be assigned a full-time staff responsible, and this staff should be fully aware of the operating instructions, trained and able to follow the instructions.

Before starting up, you should pay attention to:

No one will be injured when starting up;

 Before production, check that the Hot Plate Welding Machine For Plastic is not damaged in a place visible to the naked eye, and ensure Operate in the safest state, and report any damage to the superior immediately

Before production, non-essential objects should be removed from the machine's operating range;

During production, all safety equipment/measures should be carefully checked;

When carrying out maintenance and repair work, prevent unnecessary personnel from being within the scope of work.

If necessary, put a warning sentence in a conspicuous place to make people pay attention;

Before performing maintenance, turn off the main power supply and lock it;

When replacing parts of heavy machinery, use appropriate auxiliary tools;

Before maintenance, check whether all parts of equipment with high temperature that will be touched by maintenance personnel have been cooled to room temperature;

Care should be taken to dispose of the remaining waste after maintenance, such as lubricating oil, coolant, cleaning cotton, etc., to avoid environmental pollution.

Only qualified professionals can be responsible for repairing the electrical part of the hot plate welding machine;

Regularly check the electrical parts;

Tighten and loosen the interface regularly;

Regularly replace damaged wires and cables;

When switching the electric box, do not spray water to clean inside and outside;

Qualified professionals should be responsible for repairing hydraulic and pneumatic parts;

Protective measures: Replace the trachea regularly, even if it is not damaged, it must be prevented from hardening;

Hot Plate Welding Machine For Plastic During maintenance:

≯ Check that all screws have been tightened.

≯ All the covers that have been moved should be covered again.

After completing the warranty work, to restore the pre-production condition, you should pay attention to:

≯ All maintenance materials and tools are removed from the scope of work.

≯ All gas circuits have been adjusted normally and the operation is correct.

When disposing of the waste caused by the machine during the production operation or maintenance period, it should be implemented in accordance with the national regulations and should not be handled indiscriminately, especially the materials that can cause damage to the hostages during installation and maintenance, such as:

≯ Lubricant

≯ Coolant

≯ Cleaners containing solvents should not be discarded casually. They should be stored and packaged to the disposable range before being discarded.